|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This schema available for me in good condition. I would highly recommend.
;
Thanks for this "hard to find" service manual.
I apreciate the good quality of scanning and the pages scanned in A3 format.
;
Helpd me mont a new carradio when prewius mont was a mess.
;
Very good service and quick service, very good quality of service manual!
;
Great tape deck manual!
I'm very positively surprised, because it is a very long manual, lot of pages, drawings, diagrams, description of how to make the alignment and adjustment procedures.
It is as good as the old "Naka" manuals from the 1970's - if somebody have seen them, they know what I mean by that.
I recommend to buy this very much !
5-3. Adjustment of White Balance
¥ Operate the Zero-calibration of the CA�100, then stick sensor to PDP module surface when you adjust. ¥ For manual adjustment, it is also possible by the following sequence. (1) Select WHITE PATTERN of HEAT RUN mode by pressing ADJ button on Remote Control for adjustment then operate HEAT RUN more than 15 minute. (2) Supply Full White signal(signal output level : 85IRE) in AV Pattern Generator. (3) Select image regulation status to �Clear Image�. (4) Stick sensor to the center of screen and press the ADJ Key on R/C to select W/B and then press the VOL + Key to enter the adjustment mode. After selecting R ADJ and B ADJ, press the VOL +/- Key and adjust it until color coordination becomes(B GAIN fixation) color coordination : X=0.280±0.003, Y=0.290±0.003 color temperature : 10,000cK ± 500cK (5) Exit adjustment mode using Enter button.
- 12 -
|
|
|
> |
|
